Storage and installation of waterproof breathable membrane

one. Storage of waterproof membrane

storage method
Store unused waterproof and breathable products in the original packaging with product number and batch number. The storage time can be half a year.
Waterproof and breathable products must be kept out of direct sunlight and away from heat sources.
Waterproof and breathable products must be stored in a clean, cool, dark environment with a temperature of approximately 21°C and a humidity of approximately 50%.
two. installation method

Operation guide
Wear latex-free gloves or finger cots when handling adhesive-backed vents. Avoid direct contact with the effective breathable area or waterproof rubber ring of the product.
Waterproof and breathable products must avoid contact with rough surfaces, and sharp or jagged objects must avoid contact with the effective breathable area.
Rijin's waterproof and breathable products undergo quality inspection before shipment, but it is still recommended to self-test the waterproof and breathable membrane products before use.
Use blunt-edged tweezers to remove the waterproof and breathable product backing paper.
Note: First, slowly roll up the edge of the backing paper so that the edge of the product slightly exceeds the backing paper, and then use blunt-edged tweezers to pick up the product.

To ensure that waterproof and breathable products can be firmly bonded, lamination aids should be used for lamination. To prevent contact with the effective area, press-fitting aids should be used in accordance with the following regulations.
Allow vents to sit for 24 hours before using or testing them.