How to paste waterproof vents on glass to prevent bubbles

Step 1: Cleaning the glass windows:

First, you can use a spray bottle to fill up with water and then drop 4 to 5 drops of detergent, then shake it gradually, and then use the matching water to clean the glass windows. Here is a reminder that you can use a scraper during the cleaning process. The board is cleaned together, so that it can achieve a thorough cleaning effect. At the same time, pay attention to the cleaning of the glass frame!

Step 2: Separation:

When sticking waterproof vents, be sure to remember to tear off the protective film (we only need to stick the two sides of one corner of the film with transparent tape, and pull them apart together, so that the main film can be easily separated from the protective film). Colleagues are in The main film surface with viscous glue. Remember to spray the water that is paired with the detergent. It must be sprayed evenly. In this way, you don’t have to worry that your film will lose its stickiness. The purpose of this is to facilitate us to move and adjust. location of the membrane.

Step 3: Apply Film:

Remember to spray the detergent paired with water on the cleaned glass (it must be sprayed evenly) and paste the main film of the glass window film (with an adhesive surface, facing the glass window and paste H)

Step 4: Pad Maintenance Film:

Remember to adjust the position of the waterproof vents after they are attached, and at the same time remember to put the maintenance film that has just been torn off on the waterproof vents, so as to avoid scratching the film when wiping.

Step 5: Wipe:

After putting the protective film on, remember to use the scraper to scrape from the center to the surrounding (must be scraped in order from top to bottom) to scrape off the water and air bubbles between the waterproof vents and the glass.

Step 6: Trimming:

After the water is wiped off, the maintenance film is torn off, and then the film is pressed with a scraper. The utility knife cuts off the remaining film along the edge of the frame and you are done.