How to paste waterproof breathable film on glass so that it does not bubble

The first step: cleaning the glass window:

First, you can fill the water bottle with water and then drop 4 to 5 drops of detergent, then shake it gradually, and then clean the glass windows with the matching water. Here is a reminder that you can use the scraper during the cleaning process. The board is cleaned together, so that it can achieve a thorough cleaning effect. At the same time, pay attention to the cleaning of the glass frame!

The second step: film separation:

When sticking the waterproof breathable film, you must remember to tear off the protective film (we only need to stick the two sides of one corner of the film with transparent tape, and pull them apart together, so that the main film and the protective film can be easily separated) Colleagues Remember to spray the water matched with the detergent on the main film surface with sticky glue. It must be sprayed evenly. In this way, you don’t have to worry about your film will lose its stickiness. The purpose of this is to make it easier for us to move and adjust. location of the membrane.

The third step: the film:

Remember to spray the detergent paired with water on the cleaned glass (it must be sprayed evenly) and paste the main film of the glass window film (with an adhesive surface, facing the glass window)

Step 4: Pad Maintenance Film:

Remember to adjust the position of the waterproof and breathable membrane after attaching it, and at the same time remember to pad the maintenance membrane that has just been torn off on the waterproof and breathable membrane, so as to avoid scratching the membrane when wiping.

Step 5: Wipe:

After putting the protective film on, remember to use the scraper to scrape from the center to the surrounding (it must be scraped in order from top to bottom) to scrape off the water and air bubbles between the waterproof breathable membrane and the glass.

Step 6: Trimming:

After the water is wiped off, the maintenance film is torn off, and then the film is pressed with a scraper, and the remaining film is cut off along the edge of the frame with a utility knife, and you are done.